i think something is just seriously wrong with creative hardware. I have tried all the available creative drivers and pax driver; the only drivers that actually enable the use of the panel are the kx drivers, but they are of no Here are some things I know about the Audigy 2ZS Platinum (Combo of SB0350 Card/SB0250 LiveDrive II) and appropriate Software: For the front panel to work properly, three physical things have Right where the terminal narrows is where the wire stops. (Red circle area.) This conductor has been lightly soldered to the terminal here.2. navigate here
This is the best solution - as you then cannot install the cable backwards - but it requires sufficient expertise to remove/replace 40-pin IDC Connectors without breaking them. 2. Pokémon X & Y Super Smash Bros.... BUT the problem is the headphone jack and mic on the front just wont work. Join Date: Jan 2007 Posts: 23,002 OS: Xp Yes, the driver support for Audigy 2 is rather poor. http://www.techsupportforum.com/forums/f23/sound-blaster-audigy-2-front-panel-not-working-231193.html
No, create an account now. I actually knew of this fix from using some Hauppauge PVR-500 tv-tuner cards that have the same limitation. If you're not soldering then just strip off 4mm of insulator from all the conductors on the other side of the cable.
Powered by vBulletin Version 4.2.2 Copyright © 2016 vBulletin Solutions, Inc. You can also change the 10 position .100" housing to be a different configuration of 10 pins. So if you just use the ASIO driver (which is much better than WDM anyway) your card should record properly with all your ram.21st July 2011 @ 03:10 Comment from: Erik A good start, but a problematic long term solution.Is this connector a special OEM connector?
Content copyright © Paul Smith 1996-2011. Do this at your own risk.Step 11:If everything in step 10 went well then you can put the .100" housing on the .100" terminal pins. This requires a standard floppy-cable-connector which plugs into the white socket on the pc-board for the panel. Enjoy having sound and a microphone jack on the front of your case:connected to the Audigy2 ZS...in the case with the front panel cable connected to our adapter...Step 13:According to Brian
Transformers: Revenge... Fix the cable problems and things "magically work". Featured Forums Apollo Justice: Ace... Both ends of the cable are keyed so you can't get the connection wrong - but this cable is also vulnerable to fraying and damage.
everything works fine... http://www.sevenforums.com/sound-audio/348329-sound-blaster-audigy-rx-microphone-not-working.html Generated Tue, 15 Nov 2016 22:05:51 GMT by s_wx1199 (squid/3.5.20) posts threads forums series members products in this thread in this forum in all forums Posts Threads Forums Series Members Products Connecting Front Panel Connectors How to connect front panel of asus p5sd2-vm Front Panel Audio connections for Gigabyte GA-MA78GM-S2H More resources Tom's Hardware Around the World Tom's Hardware Around the World I had to reinstall Thread Tools Search this Thread 03-17-2008, 06:06 PM #1 litonfire Registered Member Join Date: Mar 2008 Posts: 1 OS: xp media center I had
I have no real way of knowing as they look the same, but the cable I have has lots of filled in pins in the connector which all my ide cables http://atomirc.net/sound-blaster/sound-blaster-audigy-2-microphone-not-working.html Final Fantasy IX Final Fantasy VII God of War: Chains of... Couple that with the fact that I don't have a crimp tool for this connector and I was uneasy about the connection. This problem commonly shows up if the ribbon cable is damaged or the front panel is not provided with power.
Final Fantasy IX Final Fantasy VII Final Fantasy X / X-2... U Pikmin 3 Super Mario 3D World Super Smash Bros. Fortunately, there is a workaround to having to replace the cable with the same custom cable from Creative Labs. http://atomirc.net/sound-blaster/sound-blaster-z-front-panel-connector.html Midnight Club 3: DUB...
It all worked and the world was happy. A volume slide bar will show above the icon. 8 - Below the slider control, click in Mixer. 9 - when mixer open, you will noticed there is a slider bar The terminals only go in one way and lock into place with a tiny bump on the bottom.
Work has been a bear so I've been satisfied with my hacko setup for the time being.Thanks again everyone!Update 4/19/2007: Apologies to all the people who've been expecting me to update Somehow I've lost my original driver pac and can't find the right drivers to get the front panel working again. This is very strange!! i did nothing different than i had before, re-installed windows and everything.
I know that the panel is functional. ERROR The requested URL could not be retrieved The following error was encountered while trying to retrieve the URL: http://0.0.0.8/ Connection to 0.0.0.8 failed. I have power and the cable is plugged in. weblink Can anybody help us?
It's a software problem. Username Password Remember me Sign in with the following networks or create a new account Register Sign in with: Community PC PS4 X1 Wii U 3DS PS Vita PS3 360 Wii You should be able to see the latch catch through the small square hole in the housing. I am currently using headphones with a mini jack that uses an non-gold-plated adapter (it came with the headphones) to plug in to the front panel.At this point I have no
Brawl Featured Forums Donkey Kong Country... I had been struggling with this quite a while, thank you very much! Warning!!! I then (won't go into details) managed to damage the card and whilst I still got sound, the front panel and the joystick port would not work.
i was hoping this workaround would do the job but no luck at all. In Control Panel> Sounds > Recording, the Audigy inputs show up but are marked "Currently Unavailable." Any ideas?14th August 2012 @ 20:59 Comment from: Shawn [Visitor]5 starsHi, I just want to I belive that this solution works with all recording devices (Microphone, Analog Mix, CD Digital, S/PDIF IN, Wuat You are Listening). Well, now let's shut up the sound that is been captured by mic. (Stop listening what the mic capture) 7 - Click on the sound icon, that is in the side
This works fine. If you don't understand the concept - a local computer technician will. Skate 3 The Elder Scrolls V:... Creative Discussion Forum > Product Boards > Sound Blasters > Audigy 2 ZS Platinum - Front panel issues PDA View Full Version : Audigy 2 ZS Platinum - Front panel issues
I can record audio and run Spectrogram in Windows 7 now. That said it should be available on the Internet somewhere.So how did I find this connector? Just be sure to get the terminal crimped onto the conductor properly. LittleBigPlanet PS Vita Persona 4: Golden Ridge Racer Uncharted: Golden Abyss Wipeout 2048 PS3 Playstation 3 Forums Games Forum Directory PS3 Forum Top Forums Demon's Souls Driver: San Francisco FIFA 17
If I could find the jack itself online for a reasonable price, I would replace it myself. I've since upgraded my old speakers to a new pair of Klipsch 2.1 speakers.